ACRONIS True Image 2013 User's Guide download pdf (Page 195)

If the cursor turns into two vertical lines with left and right arrows, it is pointed at the partition

border and you can drag it to enlarge or reduce the partition's size. If the cursor turns into four

arrows, it is pointed at the partition, so you can move it to the left or right (if there's unallocated

space near it).

Having provided the new location and size, click Accept. You will be taken back to the Change disk

layout window. You might have to perform some more resizing and relocation before you get the

layout you need.

By clicking Next you will proceed to the Cloning summary window.

Be careful!

Clicking any previous wizard step on the sidebar in this window will reset all size and location

changes that you've selected, so you will have to specify them again.

8.5.9 Cloning summary

The cloning summary window graphically (as rectangles) illustrates information about the source disk

(partitions and unallocated space) and the destination disk layout. Along with the disk number, some

additional information is provided: disk capacity, label, partition and file system information.

 Click Proceed to start disk cloning.

 Click Cancel to cancel the procedure and quit to the main program window.

Cloning a disk containing the currently active operating system will require a reboot. In that case,

after clicking Proceed you will be asked to confirm the reboot. Canceling the reboot will cancel the

entire procedure. After the clone process finishes you will be offered an option to shut down the

computer by pressing any key. This enables you to change the position of master/slave jumpers and

remove one of the hard drives.

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 240 241

No comments

ACRONIS True Image 2013 User's Guide Page 195