ACRONIS SNAP DEPLOY 3 - FOR WORKSTATION User's Guide download pdf (Page 119)

Tip: To find a template in the custom boot menu, press a letter key which corresponds to the first letter of the

template name. The cursor will jump on the first template whose name starts with the pressed letter.

Important: If the user-initiated deployment uses a PXE server, machines that are deployed through deployment

tasks (p. 102) will not be able to boot from that PXE server. However, deployments to such machines will be

possible if they boot from a bootable media.

The user-initiated deployment mode is primarily intended for continual work without the

administrator’s assistance. Only users (the ones on the target side) will be able to initiate deployment.

However, the administrator can view logs, create new deployment templates, change the

user-initiated deployment configuration (add, edit or remove boot menu items) and perform other

management operations except initiating the custom deployment.

10.6.2 Considerations when using a PXE server

When enabling or configuring the user-initiated deployment mode with Acronis PXE Server, the

software first removes all bootable components (Acronis Snap Deploy 5 Agent, Acronis Snap Deploy

5 Master Image Creator, and the PE image) from the PXE server, because users might be confused by

the unknown items appearing in the boot menu. Then, the software uploads to the PXE server the

templates selected by the administrator. So you will have to upload the bootable utilities again, if

they are needed after switching off the user-initiated deployment mode.

If you need to perform both user-initiated deployment and deployment through a deployment task,

you can use the PXE server for the former and bootable media for the latter.

Alternatively, you can use another Acronis Snap Deploy 5 OS Deploy Server to perform deployment

through deployment tasks, while one Acronis Snap Deploy 5 OS Deploy Server is in the user-initiated

deployment mode. To do so, ensure that the target machines connect to the appropriate

deployment server, by specifying the deployment server when creating the bootable media or by

configuring Acronis Snap Deploy 5 Agent at boot. Two deployment servers cannot use the same

Acronis PXE Server.

10.6.3 Setting up the user-initiated deployment mode

Preparation

1. Install Acronis Snap Deploy 5 Management Console and Acronis Snap Deploy 5 License Server.

Import licenses to the license server. Install Acronis Snap Deploy 5 OS Deploy Server and Acronis

PXE Server. All these components are already installed if you have performed a typical

installation (p. 45).

2. Configure and image the master system (or systems), either from a bootable media with Acronis

Snap Deploy 5 Master Image Creator (p. 74) or by using Acronis Snap Deploy 5 Management

Agent (p. 74).

To set up user-initiated deployment

1. Start Acronis Snap Deploy 5 Management Console.

2. In the welcome screen, click Configure user-initiated deployment. If prompted, specify the

machine where Acronis Snap Deploy 5 OS Deploy server is installed.

Note: If you are planning to use an Acronis PXE Server with user-initiated deployment and there are active

operations that use that PXE server, either cancel those operations or wait until they are completed, before

proceeding. See also “Considerations when using a PXE server” (p. 119).

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 144 145

No comments

ACRONIS SNAP DEPLOY 3 - FOR WORKSTATION User's Guide Page 119