Copyright © Acronis, Inc., 2000-2009 25
When using the agent on a 64-bit RedHat based distribution, such as RHEL, CentOS, Fedora or
Scientific Linux, make sure that the following 32-bit packages are installed in the system:
pam.i386
libselinux.i386
libsepol.i386
These packages should be available in the repository of your Linux distribution.
1.5. Supported file systems
Acronis Backup & Recovery 10 can back up and recover the following file systems with the following
limitations:
• FAT16/32
• NTFS
• Ext2/Ext3
• ReiserFS3 - particular files cannot be recovered from disk backups located on Acronis Backup &
Recovery 10 Storage Node
• ReiserFS4 - volume recovery without the volume resize capability; particular files cannot be
recovered from disk backups located on Acronis Backup & Recovery 10 Storage Node
• XFS - volume recovery without the volume resize capability; particular files cannot be recovered
from disk backups located on Acronis Backup & Recovery 10 Storage Node
• JFS - particular files cannot be recovered from disk backups located on Acronis Backup &
Recovery 10 Storage Node
• Linux SWAP
Acronis Backup & Recovery 10 can back up and recover corrupted or non-supported file systems
using the sector-by-sector approach.
1.6. Hardware requirements
This section lists the minimum and recommended hardware requirements to install and run Acronis
Backup & Recovery 10 components.
Acronis Backup & Recovery 10 Management Console
Item Minimum requirements Recommended
Computer processor Modern processor, 800 MHz or faster
Itanium platforms are not supported
1 GHz 32-bit (x86) or 64-bit (x64)
processor
System memory 128 MB 512 MB or more
Screen resolution 800*600 pixels 1024*768 pixels or higher
Installation disk space 50 MB
Other hardware Mouse
Network interface card or a virtual
network adapter
Comments to this Manuals